Kalys instructions for use:

• First of all, prepare your battery and mod. For more efficient and consistent rendering, use the box in TCR Mode (Temperature Coefficient of Resistance). Most mods manufactured from 2016 onwards offer this option.
• Settings may vary from one device to another. In TCR mode, set the value to 300 and use the box at 33W to get 370 ℉. This atomizer will also work in TCR Ni mode. You can then use the box with the same settings, 33W will give 370 ℉, with plus or minus 20 ℉.
  
  The Kalys will also work in Wattage mode, pulsing ignition around 30 Watts.

• Steam production will be easier by crumbling herbs more finely. You'll notice different results and steam production depending on how you pack. After a few seconds' warm-up, start sucking through the mouthpiece and hold down the button. You'll notice greater vapor production from the^3rd or^4th puff.
• Continue vaporizing until you are satisfied with no combustion. The aim is to release the beneficial components of the herb while keeping temperatures below combustion, so as not to release any carcinogenic substances. Carefully remove the plant from the chamber, preparing it for the next use.

Recommended settings for plants :

• Mode: TCR 300
• Watts: 33W
• Temperature: 370 °F / 188 ℃

Recommended settings for users:

• Mode: TCR 250
• Watts : 33W
• Temperature: 390 to 420 °F / 198 to 210 ℃

Use with plants or herbs:

1. Crumble fairly finely
2. Fill the chamber completely, without compacting it
3. Once the chamber is full, push the supplied screwdriver into the center of the chamber
4. Close the chamber with the mouthpiece
5. Spray!

If your herbs don't seem fully vaporized, you can put them back in the chamber and try again with 10 degrees more, until there's no more visual vapor.

Use with resins:

• Use only compatible resin cartridges
• Use hemp fiber
• With the same settings, use higher temperatures up to 220 ℃

Rebuilding the Kalys atomizer:

1. Remove the 3 screws from the base of the atomizer
2. Remove the ceramic shell from the top of the base
3. Remove the 2 screws from the metal base
4. Remove the cup from above
5. Replace the cup
6. Reassemble in reverse order

Find the accessories for the Kalys :

• Refurbish your Kalys with a new ceramic Kalys replacement case
• Replace the heating chamber of your Kalys: replacement ceramic heating cup
• Ø 14 mm water filter adapter
• A water filter for your Kalys, a 14 mm hydratube

Technical specifications:

• Height: ↕ 68 mm (pine 510 included)
• Width: ↔ 21.7 mm
• Diameter of mouthpiece interior: Ø 19 mm
• Heating chamber diameter: Ø 8.8 mm
• Height of heating chamber: ↕ 14.8 mm

KEEP OUT OF REACH OF CHILDREN AND/OR UNQUALIFIED PERSONS.

In the event of a technical problem with our vaporizer, a claim under the legal warranty or any question concerning the operation of the device, we invite you to contact us at contact@katalyzer.com or by mail Katalyzer, 16 boulevard de Magenta, 75010 Paris.